T10 Transmission

Posted on  by admin

Nov 22, 2012 The BORG Warner T10 transmission was manufactured from 1957 to 1987. Cast aluminum units are Super-T10 models, introduced in 1966 and manufactured until 1987. There are many different variations of the Borg Warner T10 four-speed manual transmission, because from 1957 to 1987, every American vehicle manufacturer has used the T10. Transmission mounting bolt pattern T10 B-1 case was used from 1960-64 with 221/260/289 engines that had 5 bolt blocks and the later T10 H-1 case with a dual mounting bolt pattern entered service in late 1964 for use with the 289 and later engines with a 6 bolt block. A late T10 H-1 main case will fit a 5 bolt engine bell housing because it. Richmond Gear 7021520 Super T-10 Plus 4-Speed Transmission.

Borg Warner T-10 Transmission Slip yoke 1330 Series 32 spline
Part #:
Your Cost $125.95
Sorry, sold out

1330 Series short barrel length 32 spline fits Borg Warner T-10 32 spline manual transmissions.

FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE
YOUR COST: $125.95

1330 Series short barrel length 32 spline fits Borg Warner T-10 32 spline manual transmissions.

  • Length to center of u-joint... Dimension #1 = 5 1/2 inches
  • Barrel Diameter... Dimension #2 = 1.886 inches
  • Barrel Length... Dimension #3 = 3 1/2 inches
  • U-joint cap diameter... Dimension #4 = 1 1/16 inches
  • U-joint width... Dimension #5 = 3 5/8 inches
  • Series... 1330
  • Spline count... 32

T10 Transmission Hp Rating

Transmission

T10 Transmission Codes

Enter your email address and we'll send you a message when this item is available

T10

T10 Transmission Identification

Please enter your email address in order to be notified when this item is available.